White Rust Not Anti-Corrosive Epoxy Paint 4L - HiChem

HiChem's White Rust Not Anti-Corrosive Epoxy Paint is designed to provide maximum protection against rust and corrosion. This paint utilizes a unique epoxy-based formula that forms a strong, weatherproof barrier to maximise rust prevention. Its bright white finish creates a beautiful, long-lasting finish that is sure to make your project stand out.

HICHEM RUST NOT EPOXY PAINT® is a highly durable epoxy enamel for the decoration and protection of new and old metal surfaces. Interior and exterior application. Used for wrought iron, metal structures, railings, garden furniture, gutters, downpipes, fences, gates and tools. Suitable on a variety of metal surfaces such as mild steel, galvanised and zinc coated steel, aluminium, after application of suitable primer. Also suitable on timber and concrete after application of a suitable primer or undercoat. Provides a durable corrosion and abrasion resistant finish. Easily applied. READ ALL DIRECTIONS BEFORE BEGINNING PROJECT. Painting Conditions: Use outdoors or in a well-ventilated area such as an open garage. Use when temperature is between 10°C and 32°C and humidity is below 65% to ensure proper drying. Avoid application in very windy, dusty conditions. Mask off surrounding areas to avoid overspray.
Preparation: Remove mill scale, rust and old flaking paintwork by wire brush, grinding and sanding. It is desirable to sand the whole surface. Remove all the gloss from previously painted areas by sanding with 280-400grit abrasive paper. Treat residual rust and bare metal with DEOXIDISER & RUST REMOVER. If rust cannot be removed, treat with RUST CONVERTER & PRIMER SEALER. Clean entire surface with PREPWASH. Priming: Steel: No primer is required for (a) steel under mild service conditions or for interior use or (b) when the steel is rust free or only lightly rusted. However, for superior protection of steel surfaces prime with HiChem ALL SURFACE PRIMER, METAL PRIMER, STRUCTURAL PRIMER or SUPER ETCH PRIMER. Non Ferrous surfaces: For adhesion to zinc coated steel, galvanised steel, aluminium, copper and brass; prime with SUPER
ETCH PRIMER.
Thinning: Brushing: thin up to 5% with MINERAL TURPS if required. Spraying: thin up to 15% with ENAMEL THINNER E250. If temperature exceeds 25°C thin with MINERAL TURPS. Application: Spray 2-3 medium coats allowing a drying time of 10-15 minutes between coats. Brush & roller: Apply 1 coat and allow to dry for minimum 24 hours.
Sand lightly then apply a second coat.
cooler temperatures. Dries to the touch in 2 hours and hard dry in 24 hours. To repair Dry & Recoat times: Based on 20°C and 50% relative humidity. Allow more time at
blemishes, allow to dry for 24 hours then repeat application.
Clean-up: Clean up with ENAMEL THINNER E250.