HiChem's Black Rust Not Anti-Corrosive Epoxy Paint is a durable industrial finish designed for use in high-humidity and wet areas. This water-resistant epoxy paint provides superior corrosion protection, with a long-lasting glossy finish.
A single pack epoxy enamel for the decoration and protection of new and old metal surfaces. For interior and exterior application. Used for decorating items such as wrought iron, metal structures, railings, garden furniture, gutters, downpipes, fences, gates and tools. Suitable on a variety of metal surfaces such as mild steel, galvanised and zinc coated steel, aluminium, after application of suitable primer. Also suitable on surfaction and ab timber and concrete after application of a suitable primer or undercoat. Provides a durable corrosion and abrasion resistant high gloss finish. Easily applied by brush, roller or spray.
DIRECTIONS: Stir thoroughly before use.
oil and dirt.
Surface Preparation: Remove all mill scale, rust and old flaking paintwork by wire brush, grinding and/or sanding. It is desirable to sand the whole surface. Remove all the gloss from previously painted areas by sanding with 280-400 grit abrasive paper. Clean surface with Mineral Turps to remove all traces of wax, grease, silicone, Steel: No primer is required for (a) steel under mild service conditions or for interior use or (b) when the steel is rust free or only lightly rusted. However, for superior protection of steel surfaces prime with HiChem Metal Primer, HiChem Cold Gal or HiChem Super Etch Primer. For heavier rust or if rust cannot be removed treat with Non Ferrous Surfaces: For adhesion to zinc coated or galvanised steel use Super Etch Primer or Galvanised Iron Primer. For other metals such as aluminium, copper and brass prime with Super Etch Primer.
Rust Converter & Primer Sealer then prime with Metal Primer.
Timber: Prime with Oil Based Primer for Wood.
Thinning: Brushing-thin with up to 5% by volume Mineral Turps if required.
Spraying-thin with up to 15% Enamel Thinner E250 or Mineral Turps.
Application: Apply 2 coats by brush, roller or spray. Apply first coat then allow to dry for minimum of 16 hours at 20°C allow longer at lower temperatures. Sand lightly then apply a second coat. Avoid application in damp
conditions or when temperature is less than 10°C.
Coverage: Appox 15 square meters per litre.
Drying Time: At 20°C, touch dry 2 hours, hard dry 24 hours. Recoat after 16 hours.
Cleanup: Use Enamel Thinner E250
Storage: Store in a cool dry place. Always replace the lid securely after use. For further information refer to the Product Information Sheet.
SAFETY:
Risk: Flammable. Harmful by inhalation and if swallowed. Irritating to skin.
Safety Directions: Avoid contact with the skin and eyes and avoid breathing the vapour. Wear protective clothing safety glasses and gloves. Keep away from sources of ignition-no smoking. Do not empty into drains. First Aid: For advice contact a Poisons Information Centre (Phone 13 11 26) or a doctor. If swallowed do NOT
induce vomiting.
Fire: Use dry chemical, foam, or carbon dioxide to fight fire. For additional